msgbartop
Productive Shopping For Digital Cameras
msgbarbottom

17 Sep 08 Digital Camera Battery Tips

 

Conservation Tips

Are you always running out of power just before you take that perfect with your ? Here are some tips to conserve your when you are out “snapping away”.

1) Turn off your when not in use. If you are in a situation where you must snap quickly, this may not apply as turning on and off take a few seconds, and may cause you to miss a -taking opportunity. 

However, if you are taking a leisurely stroll and can afford a couple of seconds before snapping a still subject, by all means, conserve your ’s energy!

2) Many have a regular and an LCD . While the digital LCD has its benefits, it can drain power. Turn it off when applicable and use your regular for taking .

3) Don’t stop after taking every and look at the in your ’s playback mode. Granted, you sometimes need to look at immediately after shooting them in order to make sure your exposure is correct, the lighting is ok, etc., but doing this does use up your ’s power.

4) If you are using MicroDrive media, be forewarned that these miniature hard drives may take up quite more power than Compact cards.

Taking care of you new packNormally, a new pack comes in a very low charge condition and must be fully charged before use. Refer to the user manual of your portable electronic equipment for charging instructions. A new pack needs to be fully charged and fully discharged or “cycled” as much as five times to condition them into performing at full capacity. Your equipment may report a fully charge condition in as short as 10 to 15 minutes when the new pack is being charged for the first time. This is a normal phenomenon especially for Nickel Cadmium (Ni-Cd) and Nickel Metal Hydride (Ni-MH) chemistries. When this happens, remove the pack and let it cool down for about fifteen minutes then repeat the charging procedure. “Conditioning” (fully discharging and then fully charging) is necessary so as to maintain the optimum performance of a pack, and is recommended at least once a month particularly for Ni-Cd and Ni-MH . Failure to do so could result in reduced charge capacity and can significantly shorten the packs useful life. Lithium Ion do not require conditioning. It is normal for a pack to get warm when charging and during use. However, if the pack gets excessive hot, here may be a problem with the portable electronic equipments charging circuit and should therefore be checked by a qualified technician. Rechargeable  undergo self-discharging when left unused for long periods of time. This is normal particularly in the case of Ni-MH and Li-ion chemistries. For best results, always store a pack fully charged. It should be removed from the equipment and kept in a cool, dry and clean place. The amount of runtime a pack produces depends on the power requirements of components in your electronic equipment.

Don’t let under-charged keep you from taking great .

If you infrequently use your , you may think that you after you use your , recharge your NiMH , wait a few weeks or months, then use your again, that your will be charged and you’ll be ready to snap , right?

Oops… Do that and you’ll be stuck with a non-functioning or one that just blinks a showing a dead .

Rechargeable don’t stay charged forever. They tend to lose a little bit of their power every day. If you charge your and frequently use your , you will probably never notice this loss of power. However, after a couple of weeks, the power loss may be noticeable, and after a couple of months or longer of non-use, those once ready-to-go  may have lost enough power to make them unusable.

Don’t get caught in this trap. Always charge your before every trip, and make sure to use a charger with a sensor that prevents over-charge.

more info: http://www.camera-.org

Article Source: http://www.articlesbase.com

Related posts

Tags: , , , , , , , , , , ,



Leave a Comment